anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!  |  STORE  |  Getting Started in Blacksmithing  
 
   Guru's Den   
   V.Hammer-In   
   Slack-Tub Pub II   
   Tailgate Sales   
   FAQs   
   Glossary   
   Links   
   NEWS!   
   Plans   
   Armoury   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
  Calendar of Events  
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors   
anvilfire.com General Site
Welcome visitor from
United States Flag
United States
Country Counter

Tell them you found it on anvilfire.com!

International Ceramics Products

Blacksmithing and metalworking questions answered.

I-beam Anvil :

Orange I-beam anvil from plate with Stand

Anvil made from an I beam and a heavy piece of plate.

I-Beam anvils are common in many farm and welding shops. They are OK for ocassional bending and straightening but are too springy and low mass to be good for forging. This one is a little better than most due to the heavy top plate and side ribs. The stand is as good as any.

References and Links


Page Counter Site Page Counter Copyright © 2007 - 2011 anvilfire.com