anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!   |   STORE   |   Getting Started in Blacksmithing    
 
   Guru's Den   
   Slack-Tub Pub II   
   Tailgate Sales   
   FAQs   
   Glossary   
   Plans   
   Armoury   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors   

Tell them you found it on anvilfire.com!

Tool Changing on the Phoenix Power Hammer

 
 
   
Demonstrating tool changing the Phoenix air power hammer. With Becky Little of Nova Scotia.
  1. Kiss Block for height
  2. Taper Tool
  3. Large Bottom Round Swage
  4. Small Bottom Round Swage
  5. Tongs Making Tool
  6. Big Spring Fuller
The tool holder consists of a clamp bracket with a socket for the lower die. The socket is square and has a set screw tightening clamp.




Copyright © 2010 anvilfire.com