anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!  |  STORE  |  Getting Started in Blacksmithing  
 
   Guru's Den   
   V.Hammer-In   
   Slack-Tub Pub II   
   Tailgate Sales   
   FAQs   
   Glossary   
   Links   
   NEWS!   
   Plans   
   Armoury   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
  Calendar of Events  
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors   
anvilfire.com General Site
Welcome visitor from
United States Flag
United States
Country Counter

Tell them you found it on anvilfire.com!



Gas burner made with plumbing parts, a T, union, reducer, floor flange and small blower : drawing by Jock Dempsey
Really Stupid Gas Burner
Yep! Thats all there is to it! You don't even have to use the pipe fittings if you have a piece of tubing and can do a little cutting and welding. All you would do in that case is weld a small gas pipe into the tube, letting it protrude about half way into the bigger pipe. Cut and attach a flange to the fan, rig the valve and switch and that is IT! Matter of fact you don't even need the switch/motor control. Use the cord to stop/start the fan!

NOTE: These burners require NO precision gas orifices and NO special nozzles. Just dump the gas in the air flow!

Photo of gas forge in 1985 (c) Jock Dempsey This is a "trough" or "trench" style forge I built after seeing one similar to it in California. It got hot enough to weld but pieces dropped into it were hard to retrieve. The burner assembly was identical as above except it attached with a union so it was easy to remove. The "nozzel" on this forge was shaped from the bricks and some refractory cement. I used this forge for one job and then scrapped it. Parts of it have been recycled onto my new forge. The components of the burner needed a "heat shield" between them and the forge. After a few hours of use the outside of this forge was practically glowing red hot! A piece of sheet matal set a few inches away from the forge would have reflected and absorbed the radiant heat.

This type of burner has absolutely no safety features. There must be a check valve in one end of the fuel line or the other! The regulator used was purchased from a welding supplier and is good for up to 60 PSI (400 Kpa). It is normally set to about 30 PSI (209 KPa). The single 40lb propane cylinder shown was insufficient and froze up just about the time the forge got good and hot. A second cylinder was purchased and the two manifolded together.

All the materials for this forge were purchased new (including steel and bricks) and cost $407 US in 1985. That included the cylinders and a $50 container of refractory cement that only 10% was used. The forge alone cost about $225 US. You can do a lot better with scrounged materials.

Other Gas Forge Resources


Copyright © 1998, 2005 Jock Dempsey

Counter GSC



Page Counter