anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!   |   STORE   |   Getting Started in Blacksmithing    
 

Hand Forging by Thomas F. Googerty

p.138, HAND, FORGING, Fig. 86, Sinking-Tool, square, hexagonal, tool steel, vise, Fig. 87, Fig. 87, Top Tool
   About the Book   
   Book Cover   
   Frontispiece   
   Table of Contents   
    < PREV          NEXT >   

 


    < PREV          NEXT >   

p.138 HAND - FORGING Fig. 86. Sinking-Tool of 3/4-in. square or hexagonal tool steel. The sink at the .top is filed smooth without any sharp corners and is about || in. wide and half as deep. The tool is to he caught in a vise. A top tool is also used, to fit into the sink in the lower one. This tool is shown in Fig. 87. It is simply a small Fig. 87. Top Tool

Page Counter All Page Counter anvilfire.com General Site
Copyright © 2009 anvilfire.com