flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!  |  STORE  |  Getting Started in Blacksmithing  
   Guru's Den   
   Slack-Tub Pub II   
   Tailgate Sales   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
  Calendar of Events  
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors General Site
Welcome visitor from
United States Flag
United States
Country Counter

Tell them you found it on!

International Ceramics Products

Engine Lathe, Metal Turning, Manual Lathe, Machine Tools

Chin Hung or Chinhung
KINGSTON Lathe and Attachments Machinery Sales

CHINHUNG MODEL HS-1700 16 inch X 66 inch C-C.
S/N HS0577 1985.?? (1985)
Hole Thru Spindle 2"
(16) Spindle Speeds 55 to 1800 RPM
(36) Feeds .0028 to .020 IPR, (72) Threads 4 to 42 TPI and 7 to 0.4 T/mm,
Thread Chasing Dial, Coolant System, Foot brake.
240 V 3 PH, 7.5 HP
Overall length 110". Weight about 4,000 pounds.
Similar sells new for $10,500 without accessories.

ACCESSORIES: Face Plate, 3 and 4 Jaw chucks, Steady rest, Quick change tool post and tool holders (knurl, boring bar), extra cam lock spindle adaptor, Live Center set with interchangable points, Jacobs drill chuck.

NEW ADDITION TO LISTING: Collet chuck, collets and manual draw bar.
Shop built wooden cabinet to store tools and accessories.

Swing at gap ~22.5"
Swing over bed ~16"
Swing over cariage ~8"

This is a work-horse lathe for its size and in much demand. Similar new Chin Hung lathes are still manufactured. Despite its age it has seen little use. It was purchased for our machine building business and used primarrily to make small parts, do rework as necessary and maintenance work. The shop closed in the mid 1990's and the lathe used only ocassionally for light prototype work since. It is hooked up and operating but has not been used at all for several years. Other than oil stains it is in very good condition.

$7500 OBO

Terms Cash or cleared check (allow 2 weeks). Location Rustburg, Virginia.
Pickup only. Can help load on trailer but recommend tilt bed truck.

Contact Jock Dempsey at 336-367-3499
Email: Jock Dempsey

Chin Hung Kingston Lathe

Chin Hung Kingston Lathe

Chin Hung Kingston Lathe

Chin Hung Kingston Lathe

Chin Hung Kingston Lathe

Kingston Lathe Feeds plate

Chin Hung Kingston Lathe

Granite Surface Plate
Granite 4 x 6 Surface Plate
Very low use

Click thumbnail for details

See anvilfire MACHINERY Tailgate Sales for more machinery.

Page Counter Copyright © 2012