anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!   |   STORE   |   Getting Started in Blacksmithing    
 
   Guru's Den   
   Slack-Tub Pub II   
   Tailgate Sales   
   FAQs   
   Glossary   
   Plans   
   Armoury   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors   

Tell them you found it on anvilfire.com!

Anvils in America, THE book about anvils

Blacksmithing and metalworking questions answered.



Blacksmithing and Metalworking Tools Historical Preservation.

International Ceramics Products

Super Sucker Side Draft Forge Hood by Lester Beckman

    Manufacturers      Birmingham   
Gage Inches mmInches mm
16 0.0598 1.519 0.0635 1.613
14 0.0747 1.897 0.0785 2
12 0.1046 2.657 0.1084 2.754
10 .1345 3.416 .125 3.175
The principal these work on is that the relatively small opening (compared to a large hood) creates a high velocity and sucks up the smoke and flame. The body acts as an expansion chamber and funnels the hot air and smoke into the flue.

The fire pot sits immediately below and in front of the intake. This leaves the fire open on three sides. Sometimes the intake is a foot above the firepot. If this style is used be sure to close the gap between the forge and the hood/flue. A gap lets in cold air increasing the load on the flue while reducing the efficeincy at the same time.

Often these need a sheet of burning newsprint tossed in to start the draft just before starting the forge so that your shop doesn't get smoked up. A small flap, hinged or removable extension "hood" can also increase the efficeincy for when the fire is fresh or just smouldering.

NOTES: The stack diameter can be reduced to a minimum of 10" but then the intake opening should be reduced accordingly. These have also been built with a long horizontal stack (round or square) before turning vertical. This gets the stack away from the side of the building and does not need a roof penetration.



Functioning Super Sucker Hood photos by Bernard Tappel.

References and Links


   

























Copyright © 1998, 2024 anvilfire.com