anvilfire.com flaming anvil trademark logo copyright (c) 1998 Patrick J. Dempsey
     HOME!  |  STORE  |  Getting Started in Blacksmithing  
 
   Guru's Den   
   V.Hammer-In   
   Slack-Tub Pub II   
   Tailgate Sales   
   FAQs   
   Glossary   
   Links   
   NEWS!   
   Plans   
   Armoury   
   iForge How-To    
   Health and Safety   
   Book Reviews    
   eBooks On-line   
   Anvil Gallery   
   Vice Gallery   
  Calendar of Events  
   Story Page   
   AnvilCAM - II   
  Touchmark Reg.  
   Power Hammers   
   What's New   
Comic of the Week
   Daily Comics   
Daily Metalworking Comics!
   Webring Nexus   
   Our Sponsors   
anvilfire.com General Site
Welcome visitor from
United States Flag
United States
Country Counter

Tell them you found it on anvilfire.com!




PawPaw's hold down clamp
Anvil Hold Down Clamp
by Jim "PawPaw" Wilson

This clamp is made from Vice-Grip welders clamping pliers. The lower jaw extension has has been removed and replaced by a square bar that fits in the anvil's hardy hole. The sample above was designed to take a wedge that was later found unnecessary. To operate all you do is drop the shank into the hardy hole and over a piece of work, then clamp. The loose fitting shank cocks just enough to lock in the anvil.

Copyright © 1999 Jock Dempsey


Page Counter